How to make a polycarbonate fence

A polycarbonate fence has a lot of advantages and its main feature is that it transmits light, and at the same time it is impossible to consider what happens behind the fence. But that is far from all. The material is resistant to temperature changes, can withstand heavy loads and can take the desired shape. Polycarbonate fencing practically does not require maintenance, it is enough just to periodically wash it with water. And yet, due to its cellular structure, the material perfectly absorbs street noise. Behind such a fence, even near a busy highway, you will feel comfortable. In combination with a metal fence made of art forging, polycarbonate looks very aesthetically pleasing and modern.

The attractiveness of such a fence is that it can be done independently. It is very light, it is not difficult to transport and easy to install. It is only necessary to choose what to attach to.
There are, of course, some negative aspects, although polycarbonate and durable material, but still, it is not iron or brick, if a heavy object gets into it, the fence will suffer. He also requires a strong metal mount, or else it will lead from the wind. Well, the cost of a fence made of cellular polycarbonate can be considered a drawback, although the material itself is not very expensive. But in combination with the features of fastening and artistic forging, it can come out a little expensive.

Installation itself the fence not complicated. Reinforced tape foundation, support pillars - everything is done, as for a conventional forged fence. The whole difficulty is to make a metal frame for sheets, drill polycarbonate and carefully attach it to the frame. The material does not need to be painted or processed with something, it is already ready for use. It is only important to make the correct calculation, both the total amount of material and the size of each sheet.

Polycarbonate is attached in different ways, depending on the plan of the fence. Usually simple screws, but if necessary, you can use glue, rivets or bolts. The holes should be no closer than 4 centimeters to the edge of the sheet.
It is necessary that the panels are firmly pressed to the base, so the fastenings should be on the same level, and the drilling between the stiffeners. Plates are installed vertically along stiffeners and are closed on top with a sealant or plug. After fastening, the web should not move. The holes in polycarbonate need to be done a little more, since during drilling it expands a little, and when it cools, it contracts, and the hole can be smaller than planned.

Another important point is the sealing. Seal the sheets on top with aluminum tape, and perforate them on the bottom, so that the water drains freely, and dust and dirt do not get inside.