How to drill a watering well ^Favorite

Today, many companies offer well drilling services. Using special equipment, this is done quite quickly. But such a service is not cheap. Not every landowner can afford it. If you plan to use water exclusively for irrigation, then you can drill a well on your own, without involving expensive equipment.

Most often, the aquifer is at a depth of 10 meters. And if the site is located near a natural reservoir, lake or river, then groundwater can be located higher. In the administration of each settlement there is usually a map showing the types of soil and the occurrence of groundwater. This document is not a secret and with its help you can find out where it is better to drill a well.

If the groundwater is at a depth of not more than 3 meters, then you can make a well for irrigation with a simple drill. To do this, you need to improve it a bit, that is, lengthen it. Build up the drill using pipes with a small diameter or fittings. To make it easier to pass dense layers, the drill can be weighted with additional weight. But you must remember that you can’t use water from the upper layers, it is suitable only for irrigation or technical needs.

If there are a lot of roots in the area where you are drilling a well, they need to be chopped off. For this, it is convenient to use an ax welded to the rod. When a layer of wet sand comes, usually it is at a depth of two meters, it is necessary to pull out the drill and clean it from adhering soil, otherwise it may not withstand the severity and break. It is necessary to do so constantly, every 15 to 20 centimeters of penetration.

About the approach of the aquifer will tell sand gray or bluish. As water appears, the drill needs to be cleaned, then it will not help you, the blades will not cope with liquid soil. Instead of a drill, insert the casing and deepen a little more. Then it remains only to fix the hand column, but of course the electric pump is more effective of course.