Flowers from toilet paper. Do it yourself, step-by-step instructions + 125 photos

 

DIY toilet paper flowers

let's make flowers from toilet paper, it is very easy. Take three rolls of toilet paper. Fill the two long edges with the color of your choice. Fold the toilet paper like a paper fan. Tie the thread in the middle as shown in the photo. Toilet paper made from two layers of soft paper. It is necessary to separate them at both edges and move to one side, as shown in the photo. Your toilet paper flower ready. Then wrap the sticks with a green ribbon and attach to the bottom of the flower using a little glue. Now the flowers can be put in a vase. You can even make colorful flowers.

To make toilet paper flowersyou will need the following materials:

• toilet paper
• markers
• a thread
• thin sticks
• green ribbon
• glue

• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
•  

How to make a toilet paper rose

Rose from toilet paper Is a unique way to add a special touch to a simple roll of toilet paperespecially if you are waiting for guests. If you are a professional housewife, you might want to study several origami foldsto make such a toilet paper rose. It is not that difficult. To get started, tear off one square piece of toilet paper. Set aside, then roll out another six squares. Leave these squares attached to the roll. Fold in half lengthwise, bending well.
To form rose petals from toilet paper, you will need to wrap the paper around you until you have completed all six squares.

Start at the center, close to the roll, and rotate the paper around your finger to create flower shape.

The base should be tight, and the outer rolls should be slightly loosened to give the desired shape. The square you set aside will be used for making leaves.
You fold paper from one diagonal to another with an accordion. Squeeze diagonally folded square in half to make two small sheets. Use the tiny square of transparent tape to fasten the leaf and rose. Put rose ribbonto keep her in place. The toilet paper rose is usually peeled off and put off, so you don’t have to worry about using tape to keep everything in place.

How to make simple flowers from toilet paper

This is a step-by-step guide on how to make simple but elegant. carnation toilet paper flowers. What do you need to make these carnations?

• 2 or 3 ply toilet paper (preferably white)
• Colored markers
• Some kind of thin wire
• You may need scissors

Take five pieces of 2-ply toilet paper and lay on top of each other so that they were flat. To start clove petals, fold 3-4 toilet paper; it's like making a fan, or fold accordion. The next step is to fold the toilet paper in half so that the top of the open ends is at the top and the fold is at the bottom. Then grab the tape and wrap it around folded accordion end. The next step - how to paint a clove from paper. To get started, select a color. Then squeeze the open ends of the flower and paint the border as shown in the photo. The more difficult stage is making petals.
Carefully stretch the sheets to your hands. If it breaks slightly, do not worry, as this will only add effect, but there is no need to tear it specially. Now you need to do so so that the flower is voluminous. You must separate each layer, that is, fluff. It takes a little time, but in the end everything looks good and looks more efficient.
To add a stem, take green wire and wrap around the ribbon. Then align the wire, and the flower is made of toilet paper !!!! Do a lot more to collect beautiful big bouquet.

• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
•  

Toilet paper carnation flower

To make a clove from toilet paper, separate a piece of paper from the roll, but do not separate the individual squares. Fold the toilet paper like accordion or fan. Make each crease approximately 2.5 cm wide. Fasten the middle of the folded toilet paper with thread. Fluff the folded edges. While holding the center, gently rotate each side to the center of the flower. Fold a piece on butterfly shaped green corrugated paper. Glue to the back of the flower to make leaves.

• 
• 
• 
• 
• 
•  

Cardboard Sleeve Flowers

Here is a simple example of how to make cute flowers from cardboard sleeves from paper towels. Cut the roll along. Cut off four strips ranging from 0.5 to 75 mm. Take the remaining roll and measure, mark and cut 4 cm from one of the edges. Then two strips from the same roll about 1.5 cm wide. Then take six strips and in free form cut the petalsthey do not have to be accurate, just try to make the center narrow. Glue two large petal at an angle of 90 degrees. Repeat with the remaining petals, bringing them together, large and small. If you want to add texture or, take the paint and wipe the tips of the petals dry. Can add some paint and in the central part of the flower, if desired. Now group and glue the petals, the smaller ones should be on top. After the glue has dried, glue button to the center of the flower. Cut a flower cup from a piece of paper using the pattern from fig. G.

Fold the ends of the cup by wrapping them around a brush or pencil. Take the wire and cut twice as long as the future rod. Fold the wire in half and twist.

Take one end of the wire and bend about 0.25 at a 90 ° angle. Cut a strip or two out of a brown paper bag. Starting at the straight end of the rod, glue the end of the tape to the wire and wrap the entire wire in this way. Be sure to add some glue.so that the paper is firmly fixed to the wire rod. Stop turning before turning 90 °. Make sure the glue is completely dry. Turn the flower over and glue one of the pieces of the cup to the base. Let it dry. Take the stem and glue the bend to the bottom of the flower, also glue the second piece of the cup, placing a metal bend between the cup and the flower. You will need to hold the wire until the glue dries.
Your cardboard sleeve flower is complete!

• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
•  

Flowers from toilet paper bushes

Make cheap but very pretty flowers from toilet paper bushes. For one flower you need two bushings. Cut one sleeve in the center, then into 4 equal strips. Take two of the four strips and cut 1.5 cm from both. Cut the second roll in the middle. Take every bite and cut them in shape 8. Put a little glue in the middle of one of the large workpieces, and the other large workpiece in the opposite direction and press. Put the next two blanks down as you put the last. Glue the smallest blanks and button in the middle of the flower. To make the petals, make 8 cm marks on a piece of paper. Cut the two digits of 8 and twist a little edge, using a pencil. To make the stem, take a piece of wire twice as long as the planned stem length.

Fold in half and twist a couple of times. Bend the end of the edge to got an angle of 90 °. Cut a strip from a paper bag and wrap it around the wire. Glue the leaves and the flower is ready. You can color the flowers, add shine, in general, whatever you want.

• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
•  

Toilet paper flowers 30 photos

• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
• 
•