How to paint a fence from a mesh netting ^Favorite

The netting is painted when it is already installed on the supports. There are many ways to do this.

The black metal of which the mesh is made rusts very quickly, so the surface must be prepared before painting. To do this, you need an iron wire brush, a brush (you can roller) and a primer. The grid remains on the mounts, you do not need to remove it. Remove dirt and rust with a wire brush, after which it is advisable to degrease the surface, although few do. Then a roller or brush should be applied primer, usually covered with two layers.

As the primer dries, choose one of the methods of painting.

What you will paint, does not play a big role, any product intended for painting metal surfaces is suitable. If you want it to work faster, use enamel, it dries quickly and a single layer is enough to cover the surface. And to speed up the process, use a spray gun, though it will take a lot of enamel, this is not the most economical method, albeit a quick one.
When painting, the spray gun must be held at an angle and run along the wire so that the jet captures more surface.
In order to save money, it is better to paint with a brush, just choose the one that is softer, so there will be less sagging, although they cannot be completely avoided. Using a brush can save some paint, but not time. This process is long and tedious, so be patient.

The best option to get it quickly and economically is to paint the grid together, using rollers at the same time on both sides. So things will go faster, and paint will be used up minimally. Of course, you can go for a walk on each side yourself, only it will take twice as much time.

Some more paint with a fur gauntlet turned inside out. The method is not very convenient, but effective. You put on an economic rubber glove on your hand, and a medical glove is suitable, but it is too thin for such a thing, and a turned-up mitten is placed on top. Dip your hand in enamel and then paint, so the net.

In general, choose a method that you like best or in the application of which you have more experience. The method does not matter, the result is important, so that not a single unpainted centimeter remains on the grid, only in this way can the metal be protected from corrosion.