How to install a concrete fence ^Favorite

There are some nuances that you need to pay attention to when choosing the fence. First of all, you need to find out what material was used in the manufacture of plates. Sometimes manufacturers add a lot of sand to their appearance, which affects strength. A standard slab fence is not an elite structure, so it’s better to choose less attractive, but more reliable slabs made using cement and screenings (granules).

The construction of the fence begins with the installation of concrete pillars. This can be done in two ways - in the ground or in special “glasses” prepared in the foundation. To install the "glasses" will require the involvement of technology, therefore, in self-construction usually uses the first method.

A pit up to a meter deep and about 70 cm in diameter is prepared for each pillar. Then the posts are installed, secured with temporary supports and filled with gravel. The work requires great accuracy so that there are no difficulties when installing the plates. Therefore, the proverb seven times measure just for this case. After careful measurements and adjustments, the columns are poured with a solution.

I advise you to think about creating a fence from siding, read about it and watch the video, you can here

Formwork is installed between the posts, reinforced with reinforcement and poured with concrete. When everything hardens, proceed to installation. How many assistants are needed depends on the weight of the fence sections. If you purchased monolithic plates, you will have to hire a crane. But today mainly prefabricated structures are produced that can be installed manually by a team of 4 to 5 people. Assembly takes place according to the principle of the designer, the plates are sequentially inserted into the grooves on the posts. If the posts are normally aligned, then the work will not take much time.